Then it stopped working.
Smart things hub updated linear garage door stopped working.
To do this in the smartthings app.
Totally excluded device from stplus including making sure it is excluded by holding side button for 5 seconds until beep heard.
Receive alerts from smartthings if your gocontrol garage door opener detects that your garage door has been left open for too long or opened unexpectedly.
I just tried my garage door no go.
Hub came back online garage door still not working.
I feel like mine stopped opening after the latest updates st went through.
Worked fine for 5 months and now it beeps but no open or close detects close or open if i manually do it.
Until recently i had great success with this garage door opener and st automated routines.
Replaced battery in tilt sensor and made sure it was paired with gocontrol by holding gocontrol.
Has anyone gotten the ryobi garage door opener to work.
To reset the gocontrol linear garage door opener gd00z 4 if the gocontrol linear garage door opener gd00z 4 was not detected you may need to reset or exclude the device before it can successfully connect with the smartthings hub.
Linear garage door opener stopped working.
Take take in between the manual open close and then trying to do it with the app.
Technical support is open to any consumer who purchased their z wave garage door opener on amazon.
Check the wires ensure they are connected nicely and then open close manually and then check open close from the app.
I would contact support but they will just tell me they don t support custom device handlers anyway so no point really.
Control your gocontrol garage door opener and other connected devices with the smartthings app for iphone or android.
Then fresh start smartthings and try again.
I need to replace my garage door opener as it s currently screw drive and quite loud and wakes up my wife in the bedroom above the garage.
While the hub searches press the connect button once.
2 times to get the door moving and get it back to ready state then 2 more to stop it and get it back to ready state once you have it working reliably from the physical switch make sure you set the device type in the ide for z wave virtual momentary contact switch.
Tried zwave repair says repair of garage failed issued remote boot hub now offline perfect.
From the home screen touch menu and select devices.
It is possible that through vibration the wire connection to the garage door opener may have worked loose over a year.
Linear garage door opener stopped working.
So my question is what belt drive garage door opener is the best if i want to use it with smart things.
Open and close door via manual garage door switch to reset gd00z open close sensor status.
I see a lot of info about the chamberlain and chamberlain rebrands not working and now.
So here is what t have tried so far with no solution.
