Stand back five feet or so and examine the gaps on the top and bottom.
Sliding closet doors fall off track.
Adjusting the position of the door photo 1.
Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side.
Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
First check the alignment of your closet doors.
Sliding closet doors fall off tracks.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
Take one of the doors down by lifting it and angling the bottom toward you until the rollers clear the top track then pulling it toward you.
Floor keepers are typically fastened to sliding doors by two screws.
Stand back five feet or so and examine the gaps on the top and bottom.
Sliding closet doors fall off tracks.
Moving the door when the back side is sliding on the ground is a little difficult.
Take a look and ensure the entire wheel is in one piece and properly seated in the track.
If one side of your door is loose then it s most likely that a wheel or wheel brace is faulty.
Inspect the rollers and tighten them with a.
First check the alignment of your closet doors.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
If one side of your door is loose then it s most likely that a wheel or wheel brace is faulty.
Top bracket loosen the set screw on the top bracket and slide the bracket slightly along the track to adjust the space between the top of the doors.
Take a look and ensure the entire wheel is in one piece and properly seated in the track.
Bring the door to within a few inches of the strike side jamb.
2 grab the door from both sides and lift it off the track.
Whether your door is unhinged from the top or bottom angle it at 15 to 30 degrees away from the unhinged track and slowly pull it outwards from the closet.
Bypass doors have a metal track screwed inside the top of the doorframe.